Log rafter span calculator3/17/2024 To calculate maximum rafter spans using different design criteria (load, snow load, spacing, grade, etc.) for these common lumber species, see the International Residential Code (IRC). The span values (displayed above) are from the American Softwood Lumber standard sizes. Rafters with ceiling not attached to rafters, ground snow load = 50 Psf, dead load = 20 Psf, deflection limit L/180 The following span table uses a moderate snow load of 50 Psf, but yours could be more or less. Consult your local building code authority to determine the snow load in your area. Note: Snow load factors can be specific to the regional location of a structure. Rafter Span Tables Rafters with ceiling not attached to rafters, live load = 20 Psf, dead load = 20 Psf, deflection limit L/180 The braces need to be supported by a bearing wall, shown in the diagram above.Įxample: In the rafter span table below, the highlighted cell (13-0) indicates that a 2" x 8" Douglas Fir rafter, with a grade of #2, spaced 24" apart, can have a maximum span of 13 feet - 0 inches (13-0) if designed for a live load of 20 Psf, and dead load of 20 Psf. Note also that you can break up the span of a rafter by adding a purlin and bracing to the underside. Joists supporting additional loads should be calculated by a competent person.When calculating the maximum span of a rafter, use the horizontal distance between two vertical supports. These span tables make no additional allowance for partitions or any other loads additional loads. BS 5268-7.1 was published before BS 6399-1 was amended to include the more onerous 1.4 kN imposed concentrated load, so the approach adopted for these span tables uses the recommendations given in BS 6399-1, however, both approaches do result in similar joist sizes being calculated. Other span tables are based on the guidance given in BS 5268-7.1 which is a uniformly distributed load of 1.5kN/m² for spans greater than 2400 mm and 3.6 kN load per metre width of floor for spans less than 2400 mm to ensure that very small joist sizes do not result from the calculations for smaller spans. The floor joist span tables are based on the loadings given in the amended version of BS 6399-1 which is an imposed load of either a uniformly distributed load of 1.5 kN/m² or a concentrated load of 1.4 kN. Joists are to have minimum end bearing of 40mm. Wane as allowed in BS 4978:2007+A2:2017 is permitted in all sections included in these span tables. Proprietary strutting is to be used in accordance with manufacturers recommendations. Solid timber strutting to be at least 38mm thick and be a minimum of three quarters of the joist depth.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |